5 Water Heater Tips: How to Save Money and Energy

 

Are you looking for ways to save energy and money on your water heater? If so, you’re in luck. In this post, we’ll share five helpful tips to help you do that. So whether you’re looking to buy a new water heater or want to get more out of the one you have, keep reading for some great tips. Happy savings!

  1. LOWER THE THERMOSTAT

One way to help lower your energy bills is to turn down your water heater. Water heating can account for up to 18% of your home’s energy usage, so even a small change can make a big difference. The U.S. Department of Energy recommends setting your water heater to 120 degrees Fahrenheit. This should be hot enough for most uses, but if you need it more alluring, you can always turn it up temporarily. You may also want to insulate your water heater to reduce energy loss further. These simple steps can help decrease your carbon footprint and save money on your energy bills.

  1. INSULATE TANK

Water heaters can be a significant source of energy loss in your home, but there are simple steps you can take to minimize this loss. One way to do this is to insulate your tank. This will help keep the water inside hot and reduce the energy needed to maintain the temperature. Most hardware stores can purchase an insulation blanket for your water heater. Another way to reduce energy loss is to ensure your water heater is properly insulated. This can be done by checking the R-value of the insulation and ensuring that it is above R-8. If it is not, you may need to add additional insulation. Finally, you can also install a timer on your water heater to only run when you need it. This will help reduce the time the heater is running and, as a result, save you money on your energy bill.

  1. INSTALL HEAT TRAPS

Water heaters are one of the essential appliances in your home—they provide hot water for cooking, cleaning, and bathing. Unfortunately, they can also be a significant source of energy waste. Water heater tanks typically lose heat as the water inside them cools off, and this process can account for a significant amount of wasted energy each year. To help reduce this wasted energy, consider installing heat traps on your water heater tank. Heat traps are devices that allow keeping the heat inside the tank, and they can be installed relatively easily by a qualified professional. By installing heat traps, you can help to ensure that your water heater runs more efficiently, and you can save money on your energy bills in the long run.

  1. USE COLD WATER

Water heaters are one of the most significant energy users in your home, so it’s essential to choose one that is both efficient and cost-effective. One way to do this is to install a heat trap on your water heater. Heat traps prevent heat from escaping from the tank, which means that your water will stay hot for longer periods. This can save you money on your energy bills and help extend your water heater’s life. Heat traps can also help prevent scalding by keeping the water temperature consistent. If you’re looking for ways to reduce energy usage, installing a heat trap on your water heater is a great place to start.

  1. REPAIR LEAKY FAUCETS

Water heaters are essential to any home, providing hot water for bathing, cooking, and cleaning. Unfortunately, they can also be a significant source of water leaks. A leaky water heater can waste hundreds of gallons of water each day, driving up your water bill and causing extensive damage to your home. The good news is that most water heater leaks are relatively easy to fix. Here are a few tips to help you repair a leaky water heater:

 

– First, determine the source of the leak. Water heaters leaks can occur at any point in the system, including the valves, fittings, and tank itself. Once you’ve located the source of the leak, you can begin making repairs.

 

– Second, if the leak comes from a valve or fitting, tighten or replace the affected component. If the leak comes from the tank, you may need to replace the entire unit.

 

– Third, once you’ve made repairs, test the unit by turning on the water and monitoring for leaks. If you don’t have any success repairing the leaks yourself, it’s time to call in a professional. Water heater leaks can be challenging to fix, so it’s always best to seek a professional.

 

However, there you have it – 5 easy ways to save energy and money on your water heater. We hope you found this information helpful! If you have any questions or want more tips, contact our team. We’re always happy to help!